Email:
klarcabohacikova@email.cz
Skip to content

How to Choose the Best Lumber Yard

You may feel intimidated by visiting lumber yard especially if you are new to woodworking. You may not know the exact thing you are looking for, and even if you do, you may feel out of place, and it may be difficult for you to ask for it. There is a wide range of wood that you could choose from at a lumber yard, unlike a home center. Lumber yards will arrange lumber in stacks depending on their species, and they may go as high as the ceiling. Lumber yards also have reclaimed lumber gotten form aged buildings and barns. The wide variety of products to choose from makes it difficult to settle for particular lumber since you may not know the exact product you are getting. However, choosing a lumberyard doesn’t have to be that hard as you can learn by reading through this detailed guide.

Find out about the thickness of their lumber since this is the dimension used to categorize lumber. There are a few standard thicknesses in which wood is sold depending on the size of the lumber when it is cut at the sawmill. A one-inch lumber will be called a four-quarter since the thickness is measured in quarters which are quarter-inch increments. One thing worth noting is that the boards are not perfectly flat. If you intend to have a board that will measure one inch after refining, you should get one that is a bit thicker than this and plane it down. If There is an up in it, you will have no other option but to remove material on both faces t make it even and parallel.

Look at their pricing policy. The volume of a board is measured in units called board feet, and this is what most lumber yards will use to set the prices o their lumber. To find the board feet, you multiply the width of a board by the length by the thickness (all measurements are in inches) and then dividing the final result by 144 which is a constant value.

Settle for a surfacing option that suits your needs. Dressed surfacing and rough surfacing are the two prominent surfacing options that you could pick from. Lumber with rough surfacing is straight from the sawmill with a rough and uneven surface. On the other hand, lumber that has gone through a plane is referred to as dressed lumber. Designated S2S is a term used to refer to a board that has been surfaced on both parallel sides while S4S means it has been surfaced on all four sides. You may have to pay extra for surfaced lumber.

What Research About Wood Can Teach You

What Research About Wood Can Teach You

18. 7. 2019 /